The MGA With An Attitude
MGAguru.com MGAguru.com
Carburetor HEAT SHIELD (4) -- CB-206

On September 07, 2012, Eric Russell in North Carolina, USA, wrote:
"Do you have a heat shield but it is in poor condition? A few years ago I restored a heat shield for our MGB. I found a sheet of heat resistant material that was sold to protect walls from wood stoves. After cutting the insulation material to size I attached it with 3/16 inch 'pop' rivets using 3/4 inch OD washers (aka fender washers) to back up against the insulation material".
Stove Board
Carburetor heat shield Carburetor heat shield

HomeBackTopNext
Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 2012 Barney Gaylord -- Copyright and reprint information