The MGA With An Attitude
SIDE CURTAINS For Bolt-on Hardtops - TT-110H
The first factory bolt-on hardtop was produced in June 1956. Better aerodynamics with the hardtop made the MGA about 3 MPH faster at top end, so this was immediately a hit with the racer types. The first Coupe was produced a few months later in September 1956 with a similar roof profile. For the bolt-on hardtop they supplied side curtains with rubber seal along the bottom and on the front edge, but not on top or back because the hardtop had a rubber seal there. There were rigid plastic (Plexiglas) panels front and back with the rear panel sliding and the front one fixed.
Photo above shows an original Weathershield bare aluminum side curtain to be used with the alloy hardtop. Notice seals along bottom and front, but no seals along top and back. This is because the hardtop has seals built into it. The front panel is fixed while the rear one slides
Photo below shows a Moss Motors bare aluminum side curtain placed in front of the Weathershield part. The Moss part is virtually identical to the Weathershield part except that it also has seals along the top and back, and both panels slide.
Per Confidential Service Memorandum MG/338 dated 22 Nov, 1960, all of the fabric covered side curtains were ultimately superseded by the aluminum frame units. As a result, any MGA roadster sold after that date would have been delivered with aluminum frame side curtains, same as were fitted along with bolt on hardtops.
Addendum April 28, 2022:
It has been brought to my attention that the paragraph above may not be strictly correct, and may be open to some "interpretation". Apparently there were cars produced after November 1960 still being supplied new from the factory with fabric covered side curtains. In particular, two MGA 1600-MK-II produced in November and December 1961, Black with Grey rag top and matching Grey fabric covered side curtains. So maybe this depends on when certain side curtain colors ran out of stock. Perhaps the CSM was an advisory to dealers only needing to stock two types with bare aluminum frames in inventory to service as replacement parts for all MGA.
|