The MGA With An Attitude
MGAguru.com MGAguru.com
AERODYNAMIC NUTS for Intake - TC-313

View of installed aerodynamic nut This design work is provided by Milan Zahradníček showing a special aerodynamic nut for the inside of the MGA Twin Cam intake manifold. This change requires a slight counterbore and drill inside the manifold, reduction of length of the threaded stud, and the special nut. See engineering drawings below.

Intake manifold installed with aerodynamic nuts
Machining drawing for intake manifold to accept aerodynamic nut
Engineering drawing for aerodynamic nut
Engineering drawing for threaded stud

The pictures below show an alternate approach. The picture on right is a standard manifold with the drilled hole for the stud and spotface to seat the flatwasher and self-locking nut. The picture on left is from the manifold on Robin Barker's Twin Cam YD2 2574 which was one of the five cars prepared for the 1960 Sebring race by the factory Competitions Department (but not raced at Sebring). This one has a counterbore to accept a socket head cap screw (Allen screw).

Competitions Department prepared manifold for 1960 Sebring Twin Cam
HomeBacknext
Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 2007 Barney Gaylord -- Copyright and reprint information