On Jan 3, 2024, James T in York, UK wrote:
"I will be fitting the rear bumper irons. Only problem is the rear valance has no holes (no evidence of them either). I think the rear valance has been repaired / replaced by a previous owner. I need to get these holes in the correct position before I lift the body. Would anyone be able to tell me the correct hole diameter"?



Bob Shafto in New Hudson, MI, USA wrote:
3-1/2" in from the sides and 3-1/4" inches up from first valance crease. 1-1/4" diameter hole.
The license plate wire hole is 5/8" diameter, also 3 1/4" inches up from first valance crease and centered left and right.