The MGA With An Attitude
MGAguru.com MGAguru.com
CLIPS And CLAMPS for Boots, Hoses, Pipes, Props - CF-116

Aside from listing all of these parts on one page, this is an important ingredient for proper presentation of a show car. Unless otherwise specified, "CLIP" is a P-clip, "CLAMP" is a hose clamp, and all parts are zinc plated steel. I hope to post pictures of many of these parts. The original P-clips have rolled up edges to avoid scratching pipes or abrading the wiring cables.

  for BOOTS (Rubber):
(Qty) PartNo.  Description
(1) 7H7956    Clamp for boot (large) - (clutch slave, steel wire ring)
(1) 7H7958 Clamp for boot (small) - (clutch slave, steel flat ring)
(2) 7H3565 Clamp for boot (tie rod end) - (steel wire pinch clip)
(2) ACA6004 Ring for boot (tie rod end) - (steel flat ring 1500 +early 1600)
  (2) 7H3763   Ring for boot (tie rod end) - (steel flat ring) (new part number)
ref  7H3571 Boot (rubber) - (tie rod end 1500 +early 1600)
ref  7H3562 Boot (rubber) - (tie rod end 1600) (new part number)
(2) ACA5118 Clamp for seal (small) - (rack 1500) (flat band and screw)
(2) ACA6030 Clamp for seal (large) - (rack 1500) (flat band and screw)
(2) 3H2963 Clamp - seal - small - (rack 1600) (flat band and screw)
(2) BMK924 Clamp - seal - large - (rack 1600) (flat band and screw)
ref  130801 Seal for rack (gaiter 1500)
ref  AAA1682 Seal for rack (gaiter 1600)

7H7956 & 7H7958



AHH5248
(below)
  for CABLES (Electrical):
(Qty) PartNo.  Description
(6) AHH5248    Clip for battery cable and harness - (tandem)
(2) AHH5506 Strap (steel) - tail lamp cable to rear cross member
(2) AHH5506 Strap (steel) - harness between optional dual horns
(2) ACH8979* Strap (rubber) - harness and contol cables under dash (all MGA)
(1) ACH8979* Strap (rubber) - dynamo cable to starter cable (all MGA)
  * JOHN BULL REGISTERED 747240 Type S (search eBay)
  * Anglo Parts 083.058
  * Moss Motors USA 161-850
(1) PCR0311 Clip - cable to rear number plate bracket
(2) PCR0407 Clip for tail lamp harness to side member
(1) PCR0411 Clip for tail lamp harness to bump stop
(3) PCR0607 Clip - headlamp cable to front panel
(1) PCR0607 Clip - dip switch cable to goal post (LHD 1600)
(1) PCR0609 Clip - RH (negative) cable to starter switch
(2) PCR0811 Clip - main harness to wing bolt
(2) PCR0811 Clip - head and side lamp cable to wing bolt
(2) PCR1007 Clip - main harness to bulkhead
(1) PCR1011 Clip - main harness - dash to body bolt)

(Find PCR clip dimensions at bottom of page).
  for CABLES (Pull and Turn):
(Qty) PartNo.  Description
(1) AHH5295    Clip for cable to 3-way piece & axle bracket - (hand brake)
(1) AHH5440 Clip for cable - (rubber strap for demist cable (with heater option)
(1) PCR0311 Clip - choke cable - to master cylinder blanking plate
(1) PCR0311 Clip - choke cable - (Twin Cam)
(1) PCR0507 Clip for cable to battery carrier - (hand brake)
(1) PCR0709 Clip for cable to dash (for speedo cable) (Attach to tunnel top bolt)
(1) ACH8539 Rubber sleeve for clip (speedo cable to dash)

(Find PCR clip dimensions at bottom of page).
  for HOSES:
8G632
(Qty) PartNo.  Description
(2) 95482    Clamp - hose (fuel filler) (wire type hose clamp)
  (2)  HCS1022      Clamp - hose (fuel filler) (new part number)
(4) 95621 Clamp - hose (radiator) (wire type hose clamp)
  (4)  HCS1217   Clamp - hose (radiator) (new part number)
(4) 8G632 Clamp - hose & pipe, pump to elbow (Twin Cam)
(6) 301140 Clamp - hose - (flat band with screw) (with heater option)
(1) 14G80 Clamp - Air hose to air cleaner (4" thin steel band clamp)
(3) 14G80 Clamp - Air hoses to heater (4" thin steel band clamp) (with heater)
(2) ACA5290 Clamp - air pipe (valve cover vent hose) (pinch wire clip)
(1) AHH5714 Clip - air intake hose - (carburetor side) (4" P-clip)
(1) AHH5714 Clip - air intake hose - (heater side) (4" P-clip with heater option)
(1) AHH5714 Clip - air intake hose to heater - (4" P-clip with heater option)
(2) X19546 Clamp - water pump connector hose - (wire type hose clamp)
  (2)  HCS1217   Clamp - water pump connector hose - (new part number)


For MGA Twin Cam bypass pipe:
(2) 8G518 Clamp, byass hose, thermostat end
(2) 2H3420 Clamp, byass hose, water pump end
(1) PCR1009Clip, bypass pipe
(1) AEH492Bracket, bypass pipe clip


2H3420
 

8G518

  for MECHANICAL:
(Qty) PartNo.  Description
(3) 5843    Clip for starting handle - (spring-clip in boot)
  (3)  ABD4825      Clip for starting handle - (spring-clip in boot) (new part number)
(1) 128978 Clip for support rod - (spring-clip under boot lid)
  (1)  AAA1524   Clip for support rod - (spring-clip under boot lid) (new part number)
(1) AHH5460 Clip for support rod - (spring-clip under bonnet)

  for PIPES:
(Qty) PartNo.  Description
(1) 1G2602    Clip - pipe (crankcase vent, 1600) (clip is part of pipe on 1500)
  (1) 12H981      Clip - pipe (crankcase vent, 1600) (new part number)
(1) 11G80    Clip - pipe (crankcase vent, Twin Cam)
(1) 1H840 Distance piece - clip to crankcase (crankcase vent, 1600 only)
(1) 1H841 Clip - fuel trap mounting (bracket with screw)
(1) 1K204 Clip - (vacuum pipe to rear head bolt 1500)
  (1)  12H90   Clip - (vacuum pipe to rear head bolt 1600)
(1) 54516 Clip - pipe to rear shock absorber bolt (fuel 1500)
  (1)  AAA301   Clip - pipe to rear shock absorber bolt (fuel 1600) (was 54516)
(1) ACH8650 Strap - brake pipe to axle - (thin steel band)
(1) AEH550 Clip - drain pipes, carburetors (tandem for 2 pipes)
(3) AEH550 Clip - brake pipe to bulkhead (LHD AWDB) (for 2 pipes?)
(2) AHH5436 Clip - (water return pipe) (with heater option) Use PCR0809 below
(1) CHR0309 Clip - brake pipe to toeboard (LHD)
(1) CHR0309 Clip - brake pipe to floorboard (RHD 1500)
(2) CHR0409 Clip - clutch pipe to bulkhead (LHD)
(1) CHR0411 Clip - clutch pipe to pedal excluder bolt
(2) CHR0511 Clip - fuel pipe to bulkhead (1500, early 1600)
  (2)  PCR0511   Clip - fuel pipe to bulkhead (new, always supply PCR0511)
(2) PCR0207 Clip - oil gauge pipe to bulkhead - front and rear
(1) PCR0307 Clip - main brake pipe to battery carrier
(3) PCR0307 Clip - thermometer pipe to bulkhead - front and rear
(1) PCR0309 Clip - brake pipe to RH toeboard bolt (AWDB)
(1) PCR0311 Clip - brake pipe (to pedal excluder bolt
(1) PCR0311 Clip - LH rear brake pipe to differential case bolt
(1) PCR0411 Clip - clutch pipe to pedal excluder bolt
(2) PCR0809 Clip - pipe - (oil cooler option)


Addendum 3/31/16:
BMC part numbers for the common form P-clips will look like this:
    PCR0411
PCR = P-Clip with Rolled edges
04 = tube diameter in 16ths of an inch -- (1/4-in dia pipe or cable)
11 = bolt hole diameter in 32nds of an inch -- (11/32-in hole for 5/16-in bolt)

BMC Standard C1 Cable and Pipe Clips (2.0-MB PDF file) Full P-Clips
BMC Standard C2 Cable and Pipe Clips (1.7-MB PDF file) Half P-Clips

Moss Motors has a web page listing P-Clips by dimensions if you need to buy a particular size.

HomeNext
Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 2012-2024 Barney Gaylord -- Copyright and reprint information