The MGA With An Attitude
MGAguru.com MGAguru.com
Brake Cylinder HONE - TS-122

brake hone General procedure for rebuilding any hydraulic cylinder is, disassemble, hone the bore until smooth, clean thoroughly, and reassemble with new seals. A brake hone is very cheap, likely under $10, and may save you LOTS of money in replacement parts.

See Hydraulic Tech HT-205 for detals on rebuilding hydraulic cylinders.

HomeBackTopNext
Thank you for your comments -- Send e-mail to <Barney Gaylord>
© 2010 Barney Gaylord -- Copyright and reprint information